ST-LINK/V3 programator/debugger dla STM32 STM8
towar niedostępny
Opis
Programator dla mikrokontrolerów STM8 STM32
STLINK-V3SET modułowy debugger oraz programator dla mikrokontrolerów z serii STM8 oraz STM32. STLINK-V3 umożliwia programowanie i debugowanie za pomocą interfejsów SWIM oraz JTAG/SWD.
Zestaw zawiera programator oraz moduł adaptera.
STLINK-V3SET umożliwia również komunikacje za pomocą wirtualnego portu COM, interfejsów SPI, I2C oraz GPIO.
Specyfikacja:
- Stand-alone probe with modular extensions
- Self-powered through a USB connector (Micro-B)
- USB 2.0 high-speed compatible interface
- Direct firmware update support (DFU)
- JTAG / serial wire debugging (SWD) specific features:
- 3 V to 3.6 V application voltage support and 5 V tolerant inputs
- Flat cables STDC14 to MIPI10 / STDC14 / MIPI20 (connectors with 1.27 mm pitch)
- JTAG communication support
- SWD and serial wire viewer (SWV) communication support
- SWIM specific features (only available with adapter board MB1440):
- 1.65 V to 5.5 V application voltage support
- SWIM header (2.54 mm pitch)
- SWIM low-speed and high-speed modes support
- Virtual COM port (VCP) specific features:
- 3 V to 3.6 V application voltage support on the UART interface and 5 V tolerant inputs
- VCP frequency up to 15 MHz
- Available on STDC14 debug connector (not available on MIPI10)
- Multi-path bridge USB to SPI/UART/I2C/CAN/GPIOs specific features:
- 3 V to 3.6 V application voltage support and 5 V tolerant inputs
- Signals available on adapter board only (MB1440)
- Drag-and-drop Flash programming
- Two color LEDs: communication, power
Dodatkowe informacje dostępne są na stronie producenta: