Bluetooth Slave UART Board

Bluetooth module for UART interface, slave/device mode

Overview

The Bluetooth Slave UART Board provides bluetooth solution for adding wireless capability to your development system. It is suitable for applications where wireless bluetooth data transmission is needed. The Bluetooth Slave UART Board works in slave/device mode.

We provide both "Bluetooth Master UART Board (aka, the Master Module)" and "Bluetooth Slave UART Board (aka, the Slave Module)", each of them works in single mode only. It is impossible to switch working mode for the module. The white spot on the top indicates a Master Module.

For establishing communication, there're something should be noted:

• it requires a Master Module and a Slave Module to communicate with each other
• Master Module communicate with our Slave Module only
• Master Module cannot communicate with Master Module
• Slave Module is capable to communicate with PC or mobile devices which features bluetooth capability
• Slave Module cannot communicate with Slave Module

The Master Module embeds the same AT command set with the Slave Module, expect one - the AT+NAME command, which is not embedded in the Master Module.

Both the Master Module and Slave Module are designed to use 3.3V power supply only. Be careful to use voltage translators (series connects a 1K resistor) on communication lines when connecting it to 5V systems.
 

Features

BC417, UART interface

Photos

Package Contains

• Bluetooth Slave UART Board × 1

AT COMMANDS:

1.Command:AT+VERSION 
Description:Returns the software version of the module 
Options:
Response: OKlinvorV1.5 

2.Command: AT+BAUDx 
Description:Sets the baud rate of the module The command AT+BAUD8 sets the baud rate to 115200 
Options:

• 1 >> 1200
• 2 >> 2400
• 3 >> 4800
• 4 >> 9600 (Default)
• 5 >> 19200
• 6 >> 38400
• 7 >> 57600
• 8 >> 115200
• 9 >> 230400      
                     

Response:OK115200

3.Command:AT+NAMEArduinoSolutions  
Description:Sets the name of the module  
Options:Any name can be specified up to 20 characters  
Response:OKsetname  

4.Command:AT+PINxxxx  
Description:Sets the pairing password of the device  
Options:Any 4 digit number can be used, the default pincode is 1234  
Response:OKsetPIN  

5.Command:AT+PN
Description:Sets the parity of the module
Options:AT+PN >> No parity check
Response:OK None

Check out the compatibility between "Accessory Boards" and "Development Boards"