LCD display 5" 1024×600 Touch Panel ESP32-S3 WiFi and BT CAN RS485
Regular price:
・Kup teraz i zapłać za 30 dni
product unavailable
5" 1024x600 LCD display with touch panel ESP32-S3 WiFi and BT
Development module with a 5" 1024x600 px LCD display, based on the high-performance ESP32-S3 microcontroller with a dual-core LX7 processor. Equipped with WiFi 2.4 GHz, Bluetooth 5 (LE), 16 MB Flash memory and 8 MB PSRAM, it is ideal for creating modern user interfaces (HMIs), control panels, automation systems and intelligent lighting.
With support for the free LVGL graphics library, the module allows you to seamlessly run graphical touch interfaces, also with multi-point touch support.
Key features:
-
5" IPS LCD display with 1024x600 resolution, 65K colours
-
Built-in ESP32-S3
-
Wireless connectivity: WiFi 2.4 GHz (802.11 b/g/n), Bluetooth 5 (LE)
-
Support for 5-point capacitive touch (I2C) - touch-enabled version
-
Low power support - flexible power and clock management
-
Compatible with LVGL library - for creating modern GUIs
Interoperable with many peripherals
Design of the module
- ESP32-S3-WROOM-1-N16R8
SoC with WiFi and Bluetooth, clock frequency up to 240 MHz, integrated 8MB PSRAM and 16MB Flash - TF card slot
- USB Type-C port
- BOOT button
Hold down during power-up to program the device - RESET button
- Optical isolation (optoisolator)
- Touch panel connector
- Display panel connector 5"
- RS485 and CAN terminal resistor selection
Shorted by default - Battery power on/off switch
- GH1.25 connector for single 3.7V lithium battery
- Status indicators
DONE: lithium battery charging completion indicator
CHG: lithium battery charging indicator
PWR: Power indicator
(CHG flashes and DONE lights up when DC power is connected but the lithium battery is not connected or switched off)
- DC power supply terminal 7-36V
- I2C interface terminal
VOUT output pin 5V/3.3V (switched by a resistor on the board) - CAN interface terminal
- RS485 interface terminal
- Digital output
5-36V, open drain type output, output load: max. 450mA per channel - Common input signal terminal
NC: passive input (dry contact)
Connection to supply plus: digital input active low, for NPN type active input, 5-36V DC
Connection to supply minus: digital input active high state, for input active PNP type, 5-36V DC - Digital input
5-36V, supports passive/active input (NPN or PNP) - I2C VOUT output voltage selection
For switching the output voltage and logic level of I2C VOUT, default 3.3V
- CS8501
Lithium battery charge management circuit - PCF85063
RTC chip for precise timing - AP3032KTR-G1
Display backlight voltage boost converter - CH422G
IO line extension circuit
- SP3485
RS485 transceiver - TJA1051T/3/1J
CAN transceiver - SGM2212-3.3
Low-noise 800 mA LDO regulator - Lithium battery (rechargeable)
Dimensions
Kit contents
- ESP32-S3-Touch-LCD-5B x1
- 10-pin screw connector, 3.5 mm spacing, bottom mount ×1
Wiki: https://www.waveshare.com/wiki/ESP32-S3-Touch-LCD-5
Safety
Related products
Sprawdź także:
Popular products
